Super Wet Look®
Super Wet Look® Paver Sealer from Seal n Lock is a high solid, two-part water-based pure urethane sealer that penetrates the pavers to provide a long-lasting protective barrier with superior joint stabilization (no need for polymeric sand) resulting in a ‘wet’ look.
Super Wet Look® is user friendly and environmentally safe. The high solids content of pure urethane wears evenly and lasts longer than solvent-based sealers.
All Seal ‘n Lock products are made of the most environmentally-friendly products available, and offer excellent weatherability, UV protection, and help prevent algae and mold. All of our cleaning and sealing products and specialty coatings are VOC compliant in all 50 states and exceeds all hardscape product manufacturer’s minimum standards guidelines.
Super Wet Look® is available in 2 gallon and 5-gallon kits.
Super Wet Look® Benefits:
- One day process (No downtime)
- Provides a Protective Barrier
- It May be applied to a damp surface
- User friendly and environmentally safe
- High Solids
- Minimal toxic odor
- Will not harm vegetation
- Inhibits weed growth and ant mines
- Superior joint stabilization
- No need for polymeric sand
- VOC compliant in all 50 states
- UV Protection
- Two-Part Urethane
- “Wet Look” color enhancement
- Hot tire marking resistant
Estimating Guide
Typically, the application rate will vary from 150 to 200 sq. ft. per gallon, although this rate will vary depending on the texture, absorption rate of the surface and the width of the paver joints.
Directions For Use
We recommend wearing protective goggles and latex gloves. For best results, apply Super Wet Look® at temperatures between 60° F and 90° F.
In cooler conditions, the sealer should be warmed to approximately 70° F. Do not apply if surface or ambient temperatures below 50°F. A test for compatibility, penetration and adhesion is recommended. If the temperature is going to drop below freezing (32° F) make sure the sealer has time to cure.
Mixing
Super Wet paver sealer should be diluted, after mixing part-A and part-B, 3 parts water and 1 part sealer for the flood coat and 1 part water and 1 part sealer for top coats. After mixing, the product must be used within two (2) hours and cannot be stored for future use.
Drying Time
Super Wet Look® sealer will normally dry in sunny areas within approximately 2 hours. Shaded areas, lower temperatures or high relative humidity will slow the drying process. The surface may be open to foot traffic in 24 hours and to vehicular traffic in 48 hours. To minimize tire marks, vehicles should not make sudden stops or tight turns during the curing process.
Cleanup
- Immediately flush and agitate pump system after sealing with a mixture of 5 gallons water and 4 ounces of pine sol
- Flush out the pump system with 5 gallons of fresh water
- Pour two ounces of Pine Sol into one gallon of water, run through the pump system and leave in the pump until next application.
- Always run fresh water through the pump prior to the next application
Notes
Pavers with high absorption rate will require additional top coats of sealer to provide a protective barrier and desired enhancement.
Super Wet Look® is not intended for submerged surfaces.
Maintenance
Periodic washing of pavers with a mild detergent to keep the area clean is recommended.
